New Install A06B-6060-H001 to H007

NEW INSTALL FOR A06B-6060-H001 TO A06B-6060-H007 SPINDLE DRIVE OR AN A16B-1100-0241 SPINDLE DRIVE PCB

  1. Set the jumpers to match your old spindle PCB.
  2. Move the software chips from the old spindle PCB to the new spindle PCB. See the picture below.

Failure to move the software from the old drive to the new drive will cause the display on the drive to be blank.

Please note: The chips are numbered and must be installed in the appropriate socket. Please also note the chips have a notch or key in them and so does the socket the chips go into. Please match the notch or key on the chip with the notch or key on the socket.

3. Move the NVRAM chip, which is at location MG4 (see picture below) from the old spindle PCB to the new spindle PCB. This NVRAM chip contains your parameters. It is much easier to move the chip than it is to key in the parameters manually. 

Please note: This chip and socket are also keyed and must be installed correctly.

This tech bulletin covers the following part numbers: FANUC A06B-6060-H001, A06B-6060-H002, A06B-6060-H003, A06B-6060-H004, A06B-6060-H005 A06B-6060-H006, A06B-6060-H0027, A16B-1100-0241 Spindle Drives

© 2017 TIE – Fanucworld

2017 Stevie Gold Winner for Sales & Customer Service
Tennessee Industrial Electronics, LLC, Electronic Equipment & Supplies Wholesale & Manufacturers, La Vergne, TN
nam-logo
cc-logos